1. The problem statement, all variables and given/known data
V = IR is used to define resistance. why can't it be used to define p.d.?
3. The attempt at a solution
i suggested that sometimes the current can be zero, but there is a p.d. so the equation does not hold.
but my teacher says that the answer is more towards the concept of variables, independent and dependent. i can't understand how?
thanks
Ouabache
Aug27-08, 05:25 AM
Can you please tell us what p.d is ? It is not obvious what you are referring to.
Kushal
Aug27-08, 05:29 AM
errm p.d refers to the potential difference between two points.
Defennder
Aug27-08, 06:50 AM
V=IR applies only to ohmic materials. There are a lot of devices (known as non-linear devices) for which V=IR doesn't hold ie. the potential difference across the device is not some unknown constant multiplied to the current through it. I don't get what your teacher is trying to say.
svar
Sep12-08, 06:18 PM
PD is the amount of energy per unit charge used between two points in a circuit. compare this to EMF which is the amount of energy provided to unit charge between two points. PD is across a resistor or any component that uses energy - bulb, wire, motor.
Currrent is zero when there is no PD across a component, however there is emf. consider electric motor. EMF provides current. motor moves and generates back EMF which provides back current. sum of current in the wire is reduced, so accordingly(ohm's law), PD is reduced - but the EMF of motor is there along with back EMF as this is a motor that is turning and simultaneously generating electricity as well.
make sure you know PD is joules per coulomb taken by a component, EMF is joules per coulomb given to a component - both are VOLTS.