Building a Flying Disk

[Arctic Fox]

I’ve been working on some electroGrav theories and am now wanting to start building models to try and test these theories. I’ve a 8ft satellite dish that I was thinking on using as a mold, but have no good ideas on how to go about this.

As like a “UFO”, I need to create a top and bottom curved section then mate the two parts together. I’m not sure if it can be made with wood, plastic, fibreglass or ceramic...

Anyone with ideas?

[russ_watters]

If it doesn't need to be more than about 6' in diameter, balsa-wood is great. Build a frame, then use model airplane shrink-wrap covering for the skin.

[Arctic Fox]

It’s a little more complicated than that. :)

Built like a capacitor, the top and bottom sections are each designed with a top and bottom conductive layers, seperated by a 1" insulating layer (ceramic).

Something like:

************ Fibreglass
------------ Aluminum
############ Ceramic
------------ Aluminum
************ Fibreglass