HPRF
Dec10-11, 02:41 PM
Hi,
I am trying to write a Macro in VBA to interact with a GUI in CST, specifically the Postprocessing GUI. It is to put a list of x,y coordinate into the input boxes, get the solver to evaluate for the Voltage at those points and then take the Voltage answer from that point and put it in a table for analysis (preferabley into Excel). This is to be done for several modes (different solutions).
I am very new to VBA, but have some programming knowledge. Any advice would be a great help.
Regards,
Dan
I am trying to write a Macro in VBA to interact with a GUI in CST, specifically the Postprocessing GUI. It is to put a list of x,y coordinate into the input boxes, get the solver to evaluate for the Voltage at those points and then take the Voltage answer from that point and put it in a table for analysis (preferabley into Excel). This is to be done for several modes (different solutions).
I am very new to VBA, but have some programming knowledge. Any advice would be a great help.
Regards,
Dan