View Single Post
ricky_fusion
ricky_fusion is offline
#1
Feb24-09, 04:46 AM
P: 27
Hi..

I want to analysis a G-Drill for machining process.
But, I have a little information about the drill analysis.
The objectives are the vibration and the critical point.
Does anyone have a references/information about this type of analysis??
I have a little bit information about this type of analysis and they are used for offshore drill analysis and spring analysis.
Thanks for your helpfull and I am waiting ASAP.
Phys.Org News Partner Science news on Phys.org
Better thermal-imaging lens from waste sulfur
Hackathon team's GoogolPlex gives Siri extra powers
Bright points in Sun's atmosphere mark patterns deep in its interior