View Single Post
tomek
#1
Mar8-12, 11:07 AM
P: 6
Hi,

I have a problem with "ealive" command. I make weld process simulation and I must use Workbench to do it. In COMMAND (line command) in workbench for killing compoment no. part5 I use it:

nropt,full
cmsel,s,part5
esel,a,mat,,part5
ekill,all
allsel,all
/solu

and there is corrected. But now I want to alive that compoment, so I replace "ekill" to "ealive".
Others are the same. Unfortunately it doesn't working.


Do you have some others ideas?

P.S. What is popular Ansys forum on Internet? Thanks
Phys.Org News Partner Science news on Phys.org
New type of solar concentrator desn't block the view
Researchers demonstrate ultra low-field nuclear magnetic resonance using Earth's magnetic field
Asian inventions dominate energy storage systems