Register to reply 
Testing my Bspline surface function 
Share this thread: 
#1
Feb1912, 08:32 PM

P: 194

I have created a program in MATLAB that creates a bspline surface from a set of (x,y,z) points. I would like to see if my program works before I develop it into a full program (user interface plus lots of options). Here's what I'm asking...
Could someone generate a bspline surface of degree 2 in both the u and v direction. Let's make the number of (x,y,z) control points 4 in both the u and v direction. I'm not sure what software will make a bspline surface for you with the option to change the degree. This would be very helpful. I would like to finish this so that I can post this program here. 


Register to reply 
Related Discussions  
MATLAB program for Bspline surface  Math & Science Software  10  
Testing to see if an Equation is a function  General Math  4  
Re: Building a hydrodynamics water tunnel for surface water wheel testing.  General Engineering  4  
Hypothesis Testing: Power Function  Calculus & Beyond Homework  12  
Issues testing a tachometer with a function generator  Electrical Engineering  4 