New Reply

How to tune the fuzzy logic controller in the MATLAB/SIMULINK?

 
Share Thread Thread Tools
May4-12, 04:02 AM   #1
 

How to tune the fuzzy logic controller in the MATLAB/SIMULINK?

dear all,
recently i have been doing the tuning for the fuzzy logic controller using matlab/simulink. what i need is just to micmick the PID controller. but i find it very difficult to tune it as i am just a beginner in this stage. so anyone could lend me a hand? i am about to summit my simulation in one week time.. please help me. thanks a lot. I have attached the input error and input derivative of error together with the output of the fuzzy logic controller in this post.
Attached Files
File Type: pdf senddddd.pdf (102.9 KB, 6 views)
 
PhysOrg.com
PhysOrg		 engineering news on PhysOrg.com

>> Researchers use light projector and single-pixel detectors to create 3-D images
>> GPS solution provides 3-minute tsunami alerts
>> Single-pixel power: Scientists make 3-D images without a camera
New Reply
Thread Tools


Similar Threads for: How to tune the fuzzy logic controller in the MATLAB/SIMULINK?
Thread Forum Replies
Simulating a custom discrete-time PI controller and plant in SIMULINK Math & Science Software 2
pid controller for position control in amb simulink help Engineering Systems & Design 2
is 'Fuzzy' logic an appropiate Quantum logic ?? Quantum Physics 2
what is fuzzy logic? Set Theory, Logic, Probability, Statistics 15
Fuzzy Logic General Discussion 10