Cutting time for a drill operation


by LockyPhysics
Tags: cutting, cutting time, drilling, machining, spindle speed
LockyPhysics
LockyPhysics is offline
#1
May7-12, 11:40 AM
P: 7
Can someone please help me with this exam question!!!


Calculate the cutting time for the following drilling operation:
Spindle Speed = 400RPM
Drill Diameter = 12mm
Feed Rate = 0.19mm
Component Thickness = 36mm


Any help would be appreciated... Exam tomorrow!!!
Phys.Org News Partner Engineering news on Phys.org
Fiber-optic microscope will help physicians detect cancer, diseases at early stages
Wind tunnel tests support improved aerodynamic design of B61-12 bomb
Smart sensor technology to combat indoor air pollution

Register to reply

Related Discussions
Air pressure and water height vs valve operation time Engineering Systems & Design 0
Obama: Drill Baby, Drill! Current Events 19
Drill problem, linear speed of drill bit help plz Introductory Physics Homework 1
Cutting Operation Materials & Chemical Engineering 0