|Jul31-12, 08:40 AM||#1|
Welding process in Ansys-restarting analysis
Currently I do welding process analysis in ansys, and i have a problem with restarting of analysis..
Analysis is two separated analysis, first thermal, after structural. I weld 6 edges.
When the thermal result is ready, I switch element type, load file.rth file and solve.
But in results of structural analysis I see result only from last (6th) edge. So I think, that I should use ANTYPE,TRANS,REST and FINISH. When these commands are used?
|Similar Threads for: Welding process in Ansys-restarting analysis|
|Residual stress - Ansys welding simulation||Mechanical Engineering||0|
|simulating end milling process in ansys.||Mechanical Engineering||1|
|ANSYS 2D Analysis||Engineering Systems & Design||0|
|Ansys coupled analysis||General Engineering||3|
|dimensional analysis for welding||General Engineering||0|