## What exactly is maximum symmetrical swing?

I see this term quite a lot for BJT's and I can't quite figure out exactly what it is, although I have some idea based on a bit of reading from different sources.

Is there such a thing as unsymmetrical swing, and what would that be?
 PhysOrg.com engineering news on PhysOrg.com >> NASA: Austin, calling Austin. 3-D pizzas to go>> Research suggests modular design competence can benefit new product development>> Army ground combat systems adopts tool for choosing future warfighting vehicles
 Try to analysis this example Vcc = 12V; Vc = 6V (red plot ); Ve = 2V (green plot) ; Vinput = 1V (blue plot). To make sure that BJT work in the linear region and to achieve a large voltage swing you need to set the bias point (voltage at collector) equal to 0.5Vcc (and this assumption automatically ensures that the BJT will work in the active region). And this imagines show why we need Vce = 0.5*Vcc Vce=4.5V maximum symmetrical swing +/- 4.5V Vce=3V maximum symmetrical swing +3V and -3V Vce=1V maximum symmetrical swing +1V and -1V So to amplifier our input signal waveform ( positive half and negative half) without distortion we need to set dc bias point at 0.5Vcc.
 Even if there is no clipping, you can have distorted waveform that is not symmetrical. For a resistor load common emitter stage, even harmonics are quite high and if you look at the wave form, one side is fatter and the peak amplitude is a little lower than the other side. It is progressively more prominent as the output swing increases.

## What exactly is maximum symmetrical swing?

I like the pics and explanation, Jony!

 Ah...thanks a lot for those pictures I see now what happens when the bias point is not half of Vcc. That was very helpful.