material failure


by djstar
Tags: failure, material
djstar
djstar is offline
#1
Nov10-12, 11:35 AM
P: 11
Hi,

I have been using a tensiometer to help me try and determine what the material is. one of the materials has been heat treated and and instead of a nice necking formation in the middle of the "dumbell sample" it has fractured perpendicular to the sample right next to the chucks of the tensiometer, rather then the thinner section. what is the reasoning behind this?
Phys.Org News Partner Engineering news on Phys.org
PsiKick's batteryless sensors poised for coming 'Internet of things'
Researcher launches successful tech start-up to help the blind
Researchers propose network-based evaluation tool to assess relief operations feasibility
streeters
streeters is offline
#2
Nov15-12, 08:13 AM
P: 221
was it help in too tightly? this happens with ceramics and other brittle materials a lot
pukb
pukb is offline
#3
Nov16-12, 05:07 AM
P: 90
presence of porosity at the neck section may be reason.
Improper machining at the neck region leads to improper radius which might cause stress concentration at that region causing failure much before.


Register to reply

Related Discussions
Measurement of material displacement using recorded material thermal data Materials & Chemical Engineering 3
Tensile Testing - Material Failure Prediction Engineering, Comp Sci, & Technology Homework 8
con rod failure Mechanical Engineering 6
Getting over failure General Math 9
Material Science, Material Selection Question Engineering, Comp Sci, & Technology Homework 1