Loads on bearings of winch


by bhsmith
Tags: bearings, loads, winch
bhsmith
bhsmith is offline
#1
Nov20-12, 01:28 PM
P: 37
I'm in the process of designing the drum and bearings of a winch. After reading up about types of bearings etc. I am confused about what exactly a thrust load is, and if there would be any thrust load acting on either bearing in the case of a winch with a maximum load of 2000 lbs. Any help is appreciated. Thanks
Phys.Org News Partner Engineering news on Phys.org
Researchers propose network-based evaluation tool to assess relief operations feasibility
Large streams of data warn cars, banks and oil drillers
Engineering student developing traffic forecasts
Travis_King
Travis_King is offline
#2
Nov20-12, 01:39 PM
P: 763
Type "Thrust Load" into google. It is one of the major forces when discussing bearings...
motoxYogi
motoxYogi is offline
#3
Nov20-12, 01:40 PM
P: 11
As far as I know a thrust load would be acting along the axis of the shaft the bearings are mounted on.
You'll most likely only be dealing with radial loads on the bearings.

jim mcnamara
jim mcnamara is offline
#4
Nov20-12, 01:43 PM
Sci Advisor
PF Gold
P: 1,354

Loads on bearings of winch


Thrust load acts perpendicular to the axis of rotation in your situation. Example: a car wheel --

Going down a perfectly flat straight road, there is almost no thrust load on the axle bearings (this is radial load). Steering and going around corners create thrust load.

Is that enough to help?
bhsmith
bhsmith is offline
#5
Nov20-12, 02:42 PM
P: 37
Yes thank you very much, the car example made sense.
Lsos
Lsos is offline
#6
Dec8-12, 08:10 AM
P: 768
I don't imagine a winch experiencing much thrust load. Nevertheless, there will always be some minimum amount. Probably you won't have to put in a bearing that specifically handles thrust loads, but you will need at least one on an axle that can handle both types. If you had bearings that ONLY handle radial load, then the winch would probably break apart (or at least its life be severely reduced) as soon as you turned it slightly on its side, for example.
Studiot
Studiot is offline
#7
Dec8-12, 09:57 AM
P: 5,462
Capstan winches ie those mounted vertically may well experience substantial end bearing loads or torques.

This applies to ship mounted capstans, railway haulage capstans and even bobbins in a sewing machine / loom.


Register to reply

Related Discussions
ATV quad, front wheel ball bearings not tappered roller bearings. Mechanical Engineering 1
Winch help General Engineering 0
Winch Motor Mechanical Engineering 4
Bronze bearings vs brass bearings Mechanical Engineering 0
Point Loads & Running Loads General Engineering 2