|Register to reply||
Conditions for an antinode?
|Share this thread:|
Dec6-12, 09:43 AM
If I have two sinusoidal waves with the same frequency, wavelength and amplitude, travelling along the same line in opposite directions, the net displacement of the resulting standing wave wave is given by
D(x,t) = 2a*sin(kx)*cos(ωt)
the boundary conditions for standing waves on a string from x=0 to x=L are
D(0,t) = 0 (which satisfies the above equation at all times), and
D(L,t) = 0, which satisfies the equation when L = 0.5mλ , m=1,2,3... (or λ = 2L/m)
This I understand because the displacement of a node at any time must = 0.
Now I've been told by my physics lecturer (who's not very good), that for antinodes at x = 0 and x = L, e.g. standing waves in a pool, the equation for disturbance is
D(x,t) = 2a*cos(kx)*cos(ωt),
and that the boundary conditions for antinodes at x = 0 and x = L are
D(0,t) = ±2a
D(L,t) = ±2a
which I get where this is coming from (same sort of thing as boundary conditions for nodes), but wouldn't this suggest that the displacement of x = 0 and x = L are ±2a at all times? Surely it only makes sense to say the max displacement of x = 0 and x = L is ±2a
I may just be getting confused, but if someone could shed some light on this it would help a lot!
Dec6-12, 10:35 AM
##\partial D(0,t)/\partial x## = 0
##\partial D(1,t)/\partial x## = 0
which gives ##D(0,t) = D(1,t) = 2a \cos(\omega t)##.
|Register to reply|
|Beam support conditions (Boundary Conditions) in practice||Mechanical Engineering||6|
|Find the conditions for the static coef. for non-slip conditions||Introductory Physics Homework||24|
|The maximum and minimum transverse speeds of a point at an antinode||Introductory Physics Homework||22|
|What's the difference between initial conditions and boundary conditions?||Differential Equations||9|
|About initial conditions...||Astronomy & Astrophysics||2|