- #1
gubretaw
- 10
- 0
I am constructing a full-wave bridge with the following:
- four D1N4148
- Function generator (50Hz with 10 Vpp)
- 1k ohm resistor
- Oscilloscope
I've been trying to construct the circuit, but every time I did it I always get a half-wave instead of a full-wave. All the diodes are working fine, so I don't know what is the problem.
Below is my circuit:
http://img.photobucket.com/albums/v338/mizu_awa/bridge.gif
Help anyone?
- four D1N4148
- Function generator (50Hz with 10 Vpp)
- 1k ohm resistor
- Oscilloscope
I've been trying to construct the circuit, but every time I did it I always get a half-wave instead of a full-wave. All the diodes are working fine, so I don't know what is the problem.
Below is my circuit:
http://img.photobucket.com/albums/v338/mizu_awa/bridge.gif
Help anyone?