## estimating potential drops within multi-media capacitors

I was wondering if anyone had any insights on how to estimate or discern the potential drops across a capacitor containing three distinct media between the electrode plates. The system is as follows

Vo-(+) air gap | binary electrolyte phase | plastic phase (-)

The lengths of the air gap is approximately that of the electrolyte phase, with the length of the plastic phase being much smaller. I'm trying to figure out a way to consider the the electric field at the interfaces due to the electrical double layer that should be generated by the potential difference across the capacitor.

Solving Laplace in one dimension gives

I1 = Ax+B
I2 = Cx+D
I3 = Ex+F

Applying boundary conditions I get

I1(x=0)=Vo=B
I3(x=2L)=0=2EL+F => F = -2EL

I1(x=L)=I2(x=L)
AL + Vo = CL + D

I2(x=2L)=I3(x=2L)
2CL + D = EL - 2EL
2CL + D = -EL

from conservation of charge
n*(σ1E12E2) = 0
σ of air and plastic = 0 thus
E2=0

C=0

leaving me with 3 unknowns and only two equations

AL + Vo = D
D = -EL

Which is why I am trying to see if I can estimate the approximate potential drop due to the air gap, which would allow me eliminate one of my unknowns. Still though, this is only good for determining the potential everywhere within my capacitor, and I am still no closer to determining the electric field due to the double layer at my interfaces. Any ideas?
 PhysOrg.com physics news on PhysOrg.com >> Cheap, color, holographic video: Better holographic video displays>> First entanglement between light and optical atomic coherence>> EUROnu project recommends building Neutrino Factory
 So after working on this some more I decided to try and model the system as capacitors in series... and I decided to neglect the plastic layer for this... Anyhow what I ended up doing was to draw my system as a simple circuit with two capacitors in series connected to a power source. C1=air phase C2=electrolyte phase CT=total system capacitance L = length of phase κ= dielectric constant Vo = battery voltage C=$\frac{κ*ε*A}{d}$ C1=$\frac{ε*A}{L}$ C2=$\frac{κ*ε*A}{L}$ CT=$\frac{C1*C2}{C1+C2}$=$\frac{κ*ε*A}{(1+κ)*L}$ Q=CT*Vo=$\frac{κ*ε*A*Vo}{(1+κ)*L}$ Q is conserved in series capacitors so V1=Q/C1=$\frac{κ*Vo}{(1+κ)}$ V2=Q/C2=$\frac{Vo}{(1+κ)}$ The voltage drop across the electrolyte phase should therefore be from V2 to zero Based on this, I rederived the potential function using Laplace's Eqn I1=Bx+C I2=Dx+P Considering the system from 0

 Similar discussions for: estimating potential drops within multi-media capacitors Thread Forum Replies Introductory Physics Homework 1 Introductory Physics Homework 5 Advanced Physics Homework 3 Electrical Engineering 5 Introductory Physics Homework 6