Register to reply

Load Commutation -Power Electronics in Simulink

Share this thread:
jgfdsa
#1
Sep18-13, 03:42 AM
P: 1
Dear friends

I have been using SIMULINK for some time already... I am impress with the new toolboxs and ready blocks.

Therefore, I wanted to simulate a simply load commutation, using a simple configuration of an LCI ( Load Commutated Inverter) please check picture attached.

I think by using the speed of the motor (which can be taken from Motor simulink ready block) and knowing the initial position of the rotor, can be a good control signal to trigger the thyristor. But this is not my goal, I think that with this any mosfet configuration is good enough.

I want to build a simple model which "provide" the load-commutation from the emf of the rotor. I think only applies to Synchronous Motors. ( Perhaps in Synchronous generators during braking ? )

Right now I am only introducing my idea here.

If someone would like to give a try to this I will be happy to follow this post and I am sure that together we can come up with something.
Attached Thumbnails
LCI basic circuit.jpg  
Phys.Org News Partner Engineering news on Phys.org
Printing the metals of the future
New gadget helps the vision-impaired to read graphs
3D printing helps designers build a better brick

Register to reply

Related Discussions
AC Circuit; find average and reactive power to load (and load V and I) Engineering, Comp Sci, & Technology Homework 8
Step load in matlab simulink Engineering, Comp Sci, & Technology Homework 1
Electronics - Battery voltage & load Introductory Physics Homework 11
3 Phase unbalanced load AC electronics question. Engineering, Comp Sci, & Technology Homework 0
Load Line in Electronics.. Engineering, Comp Sci, & Technology Homework 6