Register to reply

How can I power a Peltier Thermoelectric Cooler

by zmillerkoren
Tags: peltier, peltier cooler, thermo, thermo dynamics
Share this thread:
Jan25-13, 09:08 PM
P: 1
Hi I recently purchased a small (15mmx15mm) Peltier Thermoelectric Cooler/Heater. I am using this for a prototype of mine but I can't find a way to power it. The specs are 1Amp 0.8Volts.
I was just wondering if anyone knew where to find a power supply (DC) to power it. I could also use resistors, but i'm not quite sure how to do so. This all has to fit within a size of about the length of a pencil with a width of a ruler (cylinder).
Any input will be greatly appreciated, Thanks,
Phys.Org News Partner Physics news on
New complex oxides could advance memory devices
Nature's designs inspire research into new light-based technologies
UCI team is first to capture motion of single molecule in real time
Jan25-13, 11:52 PM
PF Gold
P: 1,909
zmillerkoren (Zach), Welcome to Physics Forums!

The power supply you need is: Model 442-1A: Temperature Controller

It is used in this detector:
Model ID-441-C
InGaAs Near Infrared Detector
with Preamplifier and Thermoelectric Cooler

I could not find how or where to buy it, however. Princeton Instruments and Acton Instruments sites were no help. Wherever you acquired your Peltier Thermoelectric Cooler/Heater ought to be able to either supply one, or tell you how to locate it.


Register to reply

Related Discussions
Which is more cooler? General Physics 7
Can a thermoelectric cooler be used as a thermoelectric generator? Electrical Engineering 4
Peltier Cooler connected to Power Supply, is this configuration safe? Electrical Engineering 2
CPU Cooler Classical Physics 8
DIY - Thermoelectric Peltier Seebeck Thermocouple? Electrical Engineering 0