Register to reply

Replacing a new compressor

by P@ul
Tags: compressor, replacing
Share this thread:
Feb6-14, 08:45 PM
P: 2
Hello to everyone that reads this,

I have to replace an old compressor with a new one. The trick is that i need to calculate the everything about the new one before i put it in. So i can convince everyone that it's a smart choice. The vapor compression cycle will remain the same, will still utilize the evaporator, condenser and old valve. I have temperature/pressure readings at all of those spots. From that I've determined the cop throughout the cycle at various temperatures/pressures. Now i need to make sure that compression ratio of my new compressor will work in the that unit! How do i go about that? I've also calculated the efficiency of the compressor at all of those temperatures. I don't want to over shoot it and compress it to much before the condenser and then it'll be in the sub cooled region, which would make it useless, i think. So point being, anyone know where i should start and what i can set in stone with this new compressor

Thanks guys
Phys.Org News Partner Engineering news on
'Smart material' chin strap harvests energy from chewing
Lockheed Martin advances live, virtual, constructive training in flight test
Lockheed Martin conducts flight tests of aircraft laser turret for DARPA
Feb6-14, 10:00 PM
P: 22,313
Welcome to PF!

This is an odd request. Typically a compressor replacement is pulled straight out of a catalog or selected by a sales engineer - there isn't anything for the purchaser to calculate.

Do you have the make and model of the existing condenser and its compressor?

Register to reply

Related Discussions
Replacing cathodoluminesc. by gates Atomic, Solid State, Comp. Physics 0
Replacing a battery with a different type Electrical Engineering 14
Replacing a bow and arrow. General Engineering 6
Replacing the Gasoline Engine General Discussion 18