Register to reply 
Stress and strain, maximum applied force before permanent deformation/breakage 
Share this thread: 
#1
Jun1912, 06:00 PM

P: 4

Compute the maximum longitudinal force that may be supported by a bone before breaking, given that the compressive stress at which bone breaks is 2.00e8 N/m^2. Treat the bone as a solid cylinder of radius 1.55 cm
. The attempt at a solution I tried using the equation Max Torque = pi/4 * (r^3) * max stress. Plugged in 0.0155 m for "r" and 2.00e8 N/m^2 for max stress, got 585 N*m for torque, then divided again by 0.0155 m to get the Force (377000 N). This answer wasn't accepted into webassign. What am i missing in the problem solving? 


#2
Jun1912, 10:46 PM

Sci Advisor
HW Helper
PF Gold
P: 6,036

You are calculating max torque or moment due to bending stresses, but the problem is asking, perhaps not too clearly, for max axial (longitudinal) load based on allowable axial stress. Instead of using bending stress = M/S, try using axial stress = P/A.



#3
Jun2012, 11:09 AM

P: 4

Ok. If P is the compressive force, and A is the crosssectional area that the force is applied to, I would think that A= ∏*r^2 for the surface of the cylinder. Then, multiplying A by the maximum stress 2e8 N*m^2 would yield P?



Register to reply 
Related Discussions  
Maximum Force Applied to Brakes  Introductory Physics Homework  1  
Stress vs. Strain and finding the permanent set of bar  Engineering, Comp Sci, & Technology Homework  0  
Determining maximum force applied on a lever  Engineering, Comp Sci, & Technology Homework  11  
Stressstrain diagram using deformation ?  Engineering, Comp Sci, & Technology Homework  2  
Permanent magnets & maximum force  Classical Physics  3 