Oct7-13, 04:51 PM
The problem: cracked or bent tabs upon installation of a Lexan 141 lens in to an ABS piece that causes rattles or vibrations for the customer. Need to be able to detect this condition and contain the part.
My first thought was mount a camera above the workstation and direct light in to the lens. Then use a camera to detect if the legs are bent. Below is an example.
While the image is clear and the contrast is good, I doubt detection in this manner would last long due to part variance and slight changes in operator part placement.
Anyone have another detection method I can try?
|Register to reply|
|What kinds of Magnetic assemblies can meet the needs of the motors||Electrical Engineering||3|
|Cold snap in uk||General Discussion||10|
|molecular assemblies question||Biology||3|
|Hydraulics for Landing Assemblies?||Mechanical Engineering||3|