Register to reply 
LowPass Filtering a system, Time constant issue 
Share this thread: 
#1
Jan1513, 02:46 AM

P: 3

Hi!
I want to lowpass filter some simulations that I made. The indata to the simulation is built up by several modules and hence at the edges transients will occur. I want to filter these out. The indata in sampled at 20 Hz. How should I set the time constant for the filter? I mean I know that I should relate that to the time constant of the system in order to not filter away important data. But what is the time constant of a system really? Consider a car steering system. Is the time constant the time it takes for the system to manouver from max left to max right? Or is it the time it takes to manouver from +10% to 10%? Some guideluines would be appreciated. 


#2
Jan1613, 10:29 AM

P: 3

I don't understand why do you need a LPF to do that (i mean, you "can't" do that). If you have a digital signal (the indata sampled at 20hz) just take the important data and throw away the transients. Or you can use a cyclic prefix technique or something like that.
Now, if you need to design a LPF to do another thing, the time constant is well defined in firstorder systems (it is defined in superior orders too). The definition depends of the context. 


#3
Jan1613, 10:39 AM

P: 1,803

What is the maximum rate of change of your data?



Register to reply 
Related Discussions  
First Order System's Time Constant  General Engineering  9  
Asynchronous time delayed kalman filtering  Calculus  0  
Finding the time constant of a first order system  Engineering, Comp Sci, & Technology Homework  0  
Low pass filtering  Electrical Engineering  10  
Band Pass Filtering / Discrete Fourier Tansform  Programming & Computer Science  2 