Register to reply 
Explosion force is dependent on the Amount and the said Material 
Share this thread: 
#1
Jan1114, 10:18 PM

P: 4

As I understand it; when an explosive material is set off, the force is dependent on the Amount and the said Material.
As an example, I have 2cm^{3} of dynamite I set it off and once the appropriate "oo's and ahh's" are said I set up eight separate 1cm^{3} blocks of dynamite and set them up stacked as close as possible together and to explode at the same time. Would the force be the same as the before mentioned 2cm^{3} block or would it be just eight separate outputs of force of the eight individual 1cm^{3} blocks set off together? Obviously if I set off the eight 1cm^{3} blocks individually it would just be the force of 1block, eight times, but does sticking them together ie, 2 blocks (2x1cm^{3}) create the singular output force of 2 or just two separate singular force outputs of 1? Okay, if I confused you then hopefully you can understand my confusion.. (?) I'll try break it down: Explosion1 = One 2cm^{3} block The singular force of Explosion1 has an output of 8 Explosion2 = Eight 1cm^{3} blocks together Question 1 Does it equal a singular force of 8 or does it equal eight separate outputs of 2 alongside each other? Explosion3 = One 2cm^{3} block AND One 1cm^{3} block on top Question 2 Does it equal a singular output force of 9 OR two separate outputs of 8 and 1 respectively? I hope SOMEONE who understands this can help me, I've been stuck on this during the holidays and my limited yr10 level physics doesn't help me, hopefully in this new year I might understand more. Thank you for reading. 


#2
Jan1114, 10:28 PM

Math
Emeritus
Sci Advisor
Thanks
PF Gold
P: 39,495




#3
Jan1114, 11:55 PM

P: 316

Think of it like putting rocks on a waterbed. if the rocks are spread out, there will be many small weights over a large area, and the top of the waterbed will still be relatively flat. However, if there are many rocks in a small area, they will weigh down and cause the water bed to be shaped like a funnel.
The depth of the surface of the waterbed is analogous to your force. i.e. the higher the density of explosives in a region, the more force immediately surrounding it when exploded. I would imagine the force due to an explosive (at some fixed distance/geometry) varies with the density of explosives exponentially... so summing the forces due to small amounts of explosives probably won't equal that due to a larger amount. But I'm just speculating. 


#4
Jan1214, 12:27 AM

P: 4

Explosion force is dependent on the Amount and the said Material
Corrected original post, I got lost when I posted it.



#5
Jan1214, 12:42 AM

P: 4

It would be nice if you wouldn't try pick apart every little mistake in my question, cause if I knew what I was talking about, then I wouldn't be asking it in the first place! 


#6
Jan1214, 01:43 PM

P: 415

What is sounds like your asking is: Can you reach the same physical state through multiple lower amplitude shocks as would be reached through a single higher amplitude shock?



#7
Jan1314, 08:18 PM

P: 4




#8
Jan1314, 08:59 PM

P: 1,016

When you say "2cm^{3}", do you mean 2 cubic centimeters, or a cube that is 2 centimeters on a side? Because that changes the answer...
If you mean the latter, then it would produce a shock very similar to the shock produced by 8 separate 1cm^{3} blocks placed close together. If you mean the former, the 8 smaller blocks would produce a significantly stronger shock, on account of the fact that there is significantly more explosive present. 


#9
Jan1514, 12:43 AM

P: 316

Sounds to me like the question is 
Assuming a fixed total volume of explosives, Is the sum of "forces" due to fractions of the volume (ignited seperately) equal to the "force" observed when igniting the whole volume at once. where "force" is somewhat ambiguous. If we're talking about pressure waves, let's say explosion 1 (E1) creates a maximum pressure P_{1}, and explosion 2 (E2) creates a maximum pressure P_{2}. supposing a 3rd explosion (E3), which has the sum of the volumes of explosives in E1 and E2, I would not assume that P_{3}=P_{1}+P_{2} Superposition does not hold for extreme pressures / shock waves. 


Register to reply 
Related Discussions  
Material explosion under pressure  General Physics  3  
The amount of power supplied/received by the dependent current source  Engineering, Comp Sci, & Technology Homework  10  
The motion of an object acted on by a timedependent, positiondependent force?  Calculus & Beyond Homework  3  
Amount of starting material needed for Buffer  Biology, Chemistry & Other Homework  1  
Calculating amount of fissionable material needed for reactor  Engineering Systems & Design  10 