Register to reply 
Plate thickness 
Share this thread: 
#1
Feb2314, 11:20 PM

P: 1

Hello guys, i have a problem in determining a thickness of a plate. i have a motor (m = 17 kg) attached to a plate. the design can be seen in the attachment. i need to know the dimension of "t".



#2
Feb2414, 04:45 PM

P: 163

Use a caliper if it already exists. Or, is this a homework type problem to calculate the minimum t to hold the 17kg? If you just want to make something, use 1/4" alum.



#3
Feb2414, 06:11 PM

Sci Advisor
HW Helper
PF Gold
P: 6,036

If I convert to customary USA units, the motor ways say 50 pounds lets use 100 pounds to account for vibration impacts and throw a safety factor of 4 on it. That's 400 pounds. Assume a 12 inch diameter motor 12 inches long. Moment at plate = 2400 inch pounds. Load to one bolt is 2400 divided by 12 on 2 bolts, or bolt tension = 100 pounds. Moment to inner bolts is say 1000 in pounds. Using 30000 psi steel or aluminum, the required section modulus is 1/30 inches cubed and that is 10t^2/6 solve t = about 1/8 inch. Use 1/4 inch aluminum as suggested, or use 1/4 in steel for better plate rigidity. Based on a lot of assumptions here. Disclaimer: proceed at your own risk, the author absolves himself of all responsibility. 


Register to reply 
Related Discussions  
Thickness of Plate to withstand 100psi  General Engineering  14  
Calculating Minimum Plate Thickness  General Engineering  10  
Bending of a parabolic plate with some thickness  Aerospace Engineering  4  
Cantilever Effect on Different Thickness Plate  Mechanical Engineering  7  
Base plate thickness  Mechanical Engineering  0 