Register to reply

Strength reduction factors for welded edge joints

by fpdlskf
Tags: edge, factors, joints, reduction, strength, welded
Share this thread:
fpdlskf
#1
Feb22-12, 09:29 PM
P: 8
I've looked everywhere and can't seem to find any information.

Would someone be kind enough to point me to some literature?
Phys.Org News Partner Engineering news on Phys.org
New filter technology uses inert gas to bore holes in high-quality steel
Augmented reality helps in industrial troubleshooting
How wireless technology can dramatically improve ship safety
Astronuc
#2
Feb22-12, 09:57 PM
Admin
Astronuc's Avatar
P: 21,871
I think ASME, SAE and AWS would have specific standards.

There may be examples in this publication - http://www.metalwebnews.org/ftp/weld...-TI-809-26.pdf For example, see - STRENGTH REDUCTION EFFECTS AND OTHER CONCERNS WHEN WELDING UNDER LOAD

It's usually material and geometry dependent, but then there are environmental effects as well.

By welded edge, is one thinking of lap joints or butt joints?
fpdlskf
#3
Feb22-12, 10:16 PM
P: 8
Thanks for the reply.

Quote Quote by Astronuc View Post
By welded edge, is one thinking of lap joints or butt joints?
Neither. By edge joint I mean something like this..



Register to reply

Related Discussions
How to calculate strength of welds (welded joints)? Materials & Chemical Engineering 1
Why does the LPG cylinder has to be two parts welded together Aerospace Engineering 3
Factors that affect peel strength of tape adhesives Mechanical Engineering 0
Factors affecting signal strength. Electrical Engineering 6
Equivalent stress in a welded part Mechanical Engineering 3