Register to reply

Water and Oxygen?

by Cadman5150
Tags: oxygen, water
Share this thread:
Cadman5150
#1
May12-14, 05:05 PM
P: 2
Hello gentlemen -

New to the forum here! ..... I have what I hope is an easy question for my Materials & Chemical buds.
Is there any material that is 100 percent non-corrosive against water and oxygen (sometimes nitrogen)? .... I work for a Gas Analytical company, whereas we test the permeability for different materials.
To do so, we run a mixture of water and oxygen (or nitrogen) through these units.

Not sure if I'm really explaining this well enough.
I'm basically looking for a material that will be non-corrosive, or a "treatment" that would satisfy the objective.

Any help would be so appreciated.

Mike
Phys.Org News Partner Engineering news on Phys.org
UConn makes 3-D copies of antique instrument parts
Amazon worker piloted drone around Space Needle
Five next-generation technologies for positioning, navigation and timing
Baluncore
#2
May13-14, 04:14 AM
Sci Advisor
Thanks
P: 1,749
Welcome to PF.
Maybe Polyethylene. PE powder coated.
You give chemical properties, but what physical characteristics must the material have?
Cadman5150
#3
May13-14, 01:13 PM
P: 2
Thanks Baluncore - the material would most likely be Aluminum (6061 or sim.)


Register to reply

Related Discussions
An appropriate replacement for oxygen in water Chemistry 1
CO2 exchange with Dissolved Oxygen in Water Chemistry 0
When water is boiled, and the dissolved oxygen that was in the water Chemistry 15
Decompose to water and oxygen Biology, Chemistry & Other Homework 1
Hydrogen and Oxygen from Electricity and Water Atomic, Solid State, Comp. Physics 7