2h20 to 2h2 + 02 reaction

  • Thread starter MotoPayton
  • Start date
  • Tags
    Reaction
In summary, the molecular system of water is pushed in opposite directions by the two competing goals of minimizing potential energy and maximizing entropy. This balance is set by temperature.
  • #1
MotoPayton
96
0
When enough heat is added to water to separate the bonds into hydrogen and oxygen wouldn't that heat cause the molecules to become water as soon as heat isn't being applied.

Since the oxygen and hydrogen want to be in their lower potential energy state as water.

I guess my question is how do the molecules of oxygen and hydrogen stay separate when there is this much heat around them? How are the cooled below their activation energy in order to stay separate?
 
Chemistry news on Phys.org
  • #2
I don't think thermal decomposition is a viable method of splitting water into hydrogen and oxygen.

Electrolysis is, but there both gases evolve in separate places.

--
 
  • #3
There are two driving forces behind chemical reactions. First, molecular systems move to minimize potential energy. This is usually achieved by forming bonds (covalent bonds, ionic bonds, hydrogen bonds, van der Waals interactions, etc). Second, molecular systems want to maximize their disorder (entropy). Often, breaking bonds will lead to an increase in the entropy of a system.

Thus, in many cases, molecular systems are pushed in opposite directions by these competing goals. Let's take a simple example of ice melting/water freezing. Ice consists of a highly ordered lattice of water molecules that are optimally hydrogen bonded. Because ice is so ordered, it has a very low entropy. Therefore, by the second criterion above, ice would like to melt into liquid water which has much less order and therefore much more entropy. However, in liquid water, water molecules have on average fewer hydrogen bonds than in ice. Because these hydrogen bonds stabilize water molecules and lower their potential energy, the first criterion above would seem to favor the formation of ice in order to minimize the water molecules' potential energy.

What happens to the system depends on the balance between minimizing potential energy versus maximizing entropy. If the system favors minimizing potential energy over maximizing entropy, ice should be favored over liquid water. On the other hand, if maximizing entropy is favored over minimizing potential energy, liquid water should be favored over ice.

The factor that sets this balance between these two opposing goals is temperature. At high temperatures, the system is more concerned with maximizing entropy than minimizing potential energy, and at low temperatures, the opposite situation is favored. Therefore, water freezes at low temperatures and melts at high temperatures and not the other way around.
 

1. What is the reactant in the 2h20 to 2h2 + 02 reaction?

The reactants in the 2h20 to 2h2 + 02 reaction are water (H2O) and oxygen gas (O2).

2. What type of reaction is 2h20 to 2h2 + 02?

2h20 to 2h2 + 02 is a decomposition reaction, where a compound breaks down into smaller substances.

3. What is the balanced chemical equation for 2h20 to 2h2 + 02?

The balanced chemical equation for this reaction is 2H2O → 2H2 + O2.

4. What is the purpose of the catalyst in the 2h20 to 2h2 + 02 reaction?

The catalyst in this reaction is used to speed up the rate of the reaction without being consumed itself. In this case, the catalyst is typically a metal such as platinum.

5. What are the products of the 2h20 to 2h2 + 02 reaction?

The products of this reaction are hydrogen gas (H2) and oxygen gas (O2).

Similar threads

Replies
17
Views
2K
  • Chemistry
Replies
3
Views
2K
  • Chemistry
Replies
8
Views
1K
Replies
4
Views
1K
Replies
1
Views
2K
Replies
4
Views
1K
Replies
2
Views
934
Replies
8
Views
2K
Replies
18
Views
2K
Back
Top