- #1
Eng1001
- 1
- 0
Hi,
I'm currently involved in a project designing an inertia dynamometer. Were looking for a suitable tachometer that we can use to measure the rpm with, it should give a voltage output in the form of an analogue sinusidal signal. This is so we can interphase it with a p.c.
Does anyone have any ideas where i can get one from, is it possible to stip down a scrap car to get one? Initaly it doesn't have to be to accurate because we need one to set up our programing with, later a more suitable one could be brought.
Any advice would be appreciated.
Regards...
I'm currently involved in a project designing an inertia dynamometer. Were looking for a suitable tachometer that we can use to measure the rpm with, it should give a voltage output in the form of an analogue sinusidal signal. This is so we can interphase it with a p.c.
Does anyone have any ideas where i can get one from, is it possible to stip down a scrap car to get one? Initaly it doesn't have to be to accurate because we need one to set up our programing with, later a more suitable one could be brought.
Any advice would be appreciated.
Regards...