A question about geosynchronous orbit

  • Thread starter Eriance
  • Start date
  • Tags
    Orbit
In summary, if an object in geosynchronous orbit is thrusted straight down, it will not land directly on where it was hovering as the Earth rotates. Instead, it will miss its target and crash somewhere to the east due to its retained horizontal velocity and the Coriolis force.
  • #1
Eriance
6
0
I a question regarding an object, that is originally in geosynchronous orbit, but then thrusted straight down. Will the object land directly on where it was hovering over while in the geosynchronous orbit? Or will it land off target because, as it falls, it's relative position to the Earth is no longer synchronized (earth rotates)? I'm having a hard time visualizing this.
 
Physics news on Phys.org
  • #2
Welcome to PF!

Earth rotates...and the satellite is also in orbit, revolving around the earth. So no, you can't land by thrusting straight toward Earth.
 
  • #3
Eriance said:
I a question regarding an object, that is originally in geosynchronous orbit, but then thrusted straight down.
This would require an huge amount of fuel (energy) to accomplish, but since you specifically stated "thrusted straight down", I'm assuming that the thrust is applied in the amount and direction to keep the descending satellite directly above the same point on Earth as the Earth rotates.

If instead a burst of thrust was applied perpendicular to the direction of gravity in order to slow down the satellite, it would enter an elliptical orbit. At least a second burst (again to decrease velocity) would be required to establish a lower circular orbit (at which point the satellite would orbit the Earth in less than 24 hours. Low Earth orbits take about 1 1/2 hours).

http://en.wikipedia.org/wiki/Hohmann_transfer_orbit
 
  • #4
Ah thanks, for some reason, I thought with an initial thrust the satellite will just drop out of orbit and crash into the planet. Thanks for the feedback.
 
  • #5
Eriance said:
Ah thanks, for some reason, I thought with an initial thrust the satellite will just drop out of orbit and crash into the planet.
It could if so much velocity was removed that the resulting elliptical path was so narrow that the satellite would crash into the Earth instead of orbiting around it.
 
  • #6
Let us assume that "geosynchronous" means a geostationary equatorial orbit in this case.

If "thrusted straight down" is taken to mean that the satellite fired its thrusters in a vertical direction then the satellite would surely miss the Earth -- or at least miss the point directly beneath it.

The satellite's orbit is about 22,000 miles above sea level. Add in the radius of the Earth and that's about 26,000 miles total. The circumference is two pi times that for something like 160,000 miles. It completes one orbit in just a little under 24 hours. So that's around 7,000 miles per hour.

A similar calculation shows that a point on the surface of the Earth at the equator is moving in a circular path at a little over 1,000 miles per hour.

If you fire your thusters, pushing the satellite straight down, it will retain its full orbital velocity in the horizontal direction. If you fire hard enough, it will crash into the earth. But that original horizontal velocity will mean that it will crash somewhere to the east of the point directly under where it started.

In the rotating frame of reference in which both Earth and satellite start out stationary, this is seen to be due to the Coriolis force.
 

1. What is geosynchronous orbit?

Geosynchronous orbit is a type of orbit in which a satellite orbits the Earth at the same rate that the Earth rotates, allowing the satellite to remain in a fixed position relative to the Earth's surface.

2. How high is a geosynchronous orbit?

A geosynchronous orbit is typically around 22,236 miles (35,786 kilometers) above the Earth's surface.

3. What types of satellites use geosynchronous orbit?

Communications satellites, weather satellites, and some navigation satellites use geosynchronous orbit.

4. How long does it take for a satellite in geosynchronous orbit to complete one orbit?

A satellite in geosynchronous orbit takes approximately 24 hours to complete one orbit, which is the same amount of time it takes for the Earth to rotate once on its axis.

5. What are the advantages of geosynchronous orbit?

The main advantage of geosynchronous orbit is that it allows satellites to maintain a fixed position over a specific location on Earth, making them ideal for communication and observation purposes. Additionally, the high altitude of geosynchronous orbit minimizes atmospheric drag, allowing satellites to remain in orbit for longer periods of time.

Similar threads

Replies
10
Views
954
  • Classical Physics
Replies
4
Views
996
  • Special and General Relativity
Replies
20
Views
2K
  • Astronomy and Astrophysics
Replies
0
Views
129
  • Classical Physics
Replies
16
Views
4K
  • Special and General Relativity
Replies
13
Views
1K
  • Introductory Physics Homework Help
Replies
2
Views
8K
Replies
23
Views
974
  • Astronomy and Astrophysics
Replies
2
Views
5K
Back
Top