Register to reply

OLED Watt, Ohms, and Volt Project

by ifearclassic
Tags: circuit design, problem, project
Share this thread:
ifearclassic
#1
May17-14, 07:51 PM
P: 1
Hi,
I am in fact quite new to these forums but have been lurking for a while. I am trying to design a OLED reader that will display the watts, ohms, and volts after being read from a circuit. Almost exactly like this: https://www.youtube.com/watch?v=2qjvK-Y4Mo0
Any ideas on where to start? I am not necessarily a novice when it comes to circuits but I am no expert either. Any input on a good place to start would be great!
Right now I was looking at this: http://www.alldatasheet.com/datashee...SN54LS696.html , I think this could be a vital component in creating this circuit, but once again, I would appreciate some input.
Thanks for your time.
Phys.Org News Partner Engineering news on Phys.org
DIY glove-based tutor indicates muscle-memory potential
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment
berkeman
#2
May18-14, 01:20 PM
Mentor
berkeman's Avatar
P: 41,104
Quote Quote by ifearclassic View Post
Hi,
I am in fact quite new to these forums but have been lurking for a while. I am trying to design a OLED reader that will display the watts, ohms, and volts after being read from a circuit. Almost exactly like this: https://www.youtube.com/watch?v=2qjvK-Y4Mo0
Any ideas on where to start? I am not necessarily a novice when it comes to circuits but I am no expert either. Any input on a good place to start would be great!
Right now I was looking at this: http://www.alldatasheet.com/datashee...SN54LS696.html , I think this could be a vital component in creating this circuit, but once again, I would appreciate some input.
Thanks for your time.
Welcome to the PF.

Are you intending to measure the power being consumed from an AC Mains connection? It sounds like you don't have much experience with circuits, let alone AC Mains high-voltage circuits and safety...?


Register to reply

Related Discussions
Finding Current given kilo-ohms and volt Introductory Physics Homework 8
Unlimited resistors to build a 5 watt circuit with resistance of 10 ohms. Advanced Physics Homework 1
Conversion volt/ohms to uA Introductory Physics Homework 1
Integrating Digital Volt/Amp/Watt Meters and MOEPED news General Physics 1
Calculate the maximum current a 140 ohms, 1/2 watt Introductory Physics Homework 1