Energy transfer in electromagnetic induction

In summary: Since the field lines extend outward from the magnet, the speed at which the field lines can propagate is limited by the speed of light. Thus, there will be a delay before the field lines reach the coil.
  • #71
But there is no noticeable increase in the radiation energy. (v<<c)

If the electromagnet radiates isotropically in its frame (if it has symmetric shape), the energy radiated into all directions per unit time is Lorentz invariant; it is the same in all frames. Let's say the electromagnet radiated 1 J in one second, in its own frame of reference.

What is important, is that in the frame of the coil, the electromagnet is moving towards it. When a source of isotropic radiation moves in some direction, the radiation is released preferentially to that direction. Check

https://en.wikipedia.org/wiki/Synchrotron_radiation

The bunches of charged particles circling in synchrotron move so fast that the radiation is needle-like, similar to laser, only much brighter and not monochromatic.

With the electromagnet, it is similar; even if it moves slowly, there is more radiation going to the coil than in the other directions.

As the velocity is increased, coil receives greater and greater power. However, there is a limit: when v approaches c, the coil receives almost all the radiated power 1 J/s and this is the maximum. Of course, as the processes in the source are slowed down (dilatation) , it will receive it for a long time and thus the net amount of energy received in the end can be much greater than 1 J.

Where did the extra energy came from? From the total energy of the electromagnet; as the net energy of the electromagnet decreases by radiation, in the frame of the coil the electromagnet loses also momentum via loss of its mas (the velocity is unaffected).
 
Physics news on Phys.org
  • #72
entropy15 said:
The point I was trying to make was that the initail energy due to the current induced in the coil is entirely due to the electromagnetic wave.
The kinetic energy of the electromagnet cannot contribute to the induced current, as it does not decrease initailly.
The EM wave is what carries the KE away. The KE of the magnet does decrease as soon as the electromagnet radiates. Remember, the KE decreases due to the loss of mass from radiating energy, even if the velocity remains constant.

entropy15 said:
Lets consider the time interval between x/c and when the coil begins to feel resistance due to mutaul induction. It will be less than 2x/c since the electromagnet is moving towards the coil.
The energy due to the current in the coil during this time cannot be greater than the energy in the electromagnetic wave intially radiated.
Yes, that is not in doubt at all. The point is that the energy in the EM wave depends on the reference frame. In reference frames where the magnet was initially moving the energy in the EM wave is greater than in the frame where it was stationary. Energy is frame variant.

entropy15 said:
But if we increase the value of v, the energy in the coil increases because of a larger change in flux. But there is no noticeable increase in the radiation energy. (v<<c)
No noticeable increase in the TOTAL radiation energy, but there is a noticeable increase in the energy through the coil. Doppler.

entropy15 said:
If we consider the frame of the moving electromagnet there is no Doppler effect.
This is incorrect, the Doppler effect depends only on the relative velocity. In any frame there is the exact same amount of Doppler effect. In the magnet's frame, of course, the Doppler effect is due entirely to the movement of the loop.

entropy15 said:
All the electromagnet sees is the coil moving towards it.
Here again we can see that the energy in the coil (between x/c and 2x/c) increases with increase in the relative velocity.
Doppler.
 
  • #73
Jano L. said:
As the velocity is increased, coil receives greater and greater power. However, there is a limit: when v approaches c, the coil receives almost all the radiated power 1 J/s and this is the maximum..

You mean to say that there is limit to the energy that can be transferred to the coil between the interval x/c and 2x/c.

Can we not increase the energy transferred initially by increasing the number of turns in the coil. More turns mean more current flowing in the coil.
 
  • #74
This goes back to the point before. I think DaleSpam's answer was: "Think about the field generated by the induced current in the first turn. How does that affect the total field seen by the second turn. My hint is that the equation:
[tex]\displaystyle{\varepsilon}=-N \frac{d \Phi}{dt} [/tex]
Uses a lot of assumptions, and if you break those assumptions, you cannot expect the equation to give correct results.

Edit: actually, it doesn't use a lot of assumptions, but the simple case of increasing number of turns to increase the current through the coil does introduce assumptions.

Another Edit: and generally, it is assumptions used along with this equation that have caused the problems in this thread. For example, the assumption "that the magnetic field at the magnet and at the coil is approximately the same" is often used with this equation, but this assumption becomes false when the magnet and coil are far away from each other.
 
Last edited:
  • #75
entropy15 said:
You mean to say that there is limit to the energy that can be transferred to the coil between the interval x/c and 2x/c.

Can we not increase the energy transferred initially by increasing the number of turns in the coil.
In addition to BruceW's point above, I would like to point out that the two statements are not mutually exclusive. Specifically, it is possible that the statements "there is a limit to the energy that can be transferred" and "we can increase the energy transferred by increasing the number of turns" can both be true.
 
Last edited:
  • #76
DaleSpam said:
In addition to BruceW's point above, I would like to point out that the two statements are not mutually exclusive. Specifically, it is possible that the statements "there is a limit to the energy that can be transferred" and "we can increase the energy transferred by increasing the number of turns" can both be true.

How is that possible?
 
  • #77
entropy15 said:
How is that possible?
Like this (ignore the scale and units of the vertical axis, this is just to give a general idea of the concept of a monotonically increasing function with a horizontal asymptote)
1-s2.0-S0022509608001993-gr8.jpg

If each dot represents the energy extracted by a coil with i turns then it is both true that "there is a limit to the energy that can be transferred" and "we can increase the energy transferred by increasing the number of turns".
 
Last edited:
  • #78
DaleSpam said:
Like this (ignore the scale and units of the vertical axis, this is just to give a general idea of the concept of a monotonically increasing function with a horizontal asymptote)

Thanks for clarifying. This seems to indicate that the amount of energy transferred converges to a fixed value as N (no. of turns) tends to infinity.

Is this because the successive turns in the coil are linked to lesser magnetic flux?
 
  • #79
Yes, it is because each turn reduces the flux seen by the other turns. This can be seen through the superposition principle.

Suppose that you have two turns, consider them to be two separate loops. There is a current in loop A which creates a field which opposes the change in the external field. By superposition the field seen by loop B is the sum of the field from loop A and the external field, which is less than the change in the external field. So the current induced in B is a function of the external field and the current induced in A where current in A reduces the induced current in B.

Then, to consider the loops as separate turns in a single coil simply equate the current in A to the current in B.
 
Last edited:
<h2>1. What is electromagnetic induction?</h2><p>Electromagnetic induction is the process of generating an electric current in a conductor by varying the magnetic field around it. This is achieved by either moving the conductor through a stationary magnetic field or by varying the magnetic field through the conductor.</p><h2>2. How does energy transfer occur in electromagnetic induction?</h2><p>Energy transfer in electromagnetic induction occurs through the conversion of magnetic energy into electrical energy. As the magnetic field changes, it induces an electric field in the conductor, causing the free electrons in the conductor to move and generate an electric current.</p><h2>3. What factors affect the amount of energy transferred in electromagnetic induction?</h2><p>The amount of energy transferred in electromagnetic induction is affected by the strength of the magnetic field, the speed at which the conductor moves or the magnetic field changes, and the properties of the conductor such as its length and material.</p><h2>4. What are some practical applications of electromagnetic induction?</h2><p>Electromagnetic induction has many practical applications, such as in generators and transformers for generating and transmitting electricity, in motors for converting electrical energy into mechanical energy, and in induction cooktops for heating food using a magnetic field.</p><h2>5. How is electromagnetic induction related to Faraday's law and Lenz's law?</h2><p>Faraday's law states that the induced electromotive force (EMF) in a closed loop is directly proportional to the rate of change of the magnetic flux through the loop. Lenz's law states that the direction of the induced current in a conductor will be such that it opposes the change that caused it. Both of these laws play a crucial role in understanding and predicting the behavior of electromagnetic induction.</p>

1. What is electromagnetic induction?

Electromagnetic induction is the process of generating an electric current in a conductor by varying the magnetic field around it. This is achieved by either moving the conductor through a stationary magnetic field or by varying the magnetic field through the conductor.

2. How does energy transfer occur in electromagnetic induction?

Energy transfer in electromagnetic induction occurs through the conversion of magnetic energy into electrical energy. As the magnetic field changes, it induces an electric field in the conductor, causing the free electrons in the conductor to move and generate an electric current.

3. What factors affect the amount of energy transferred in electromagnetic induction?

The amount of energy transferred in electromagnetic induction is affected by the strength of the magnetic field, the speed at which the conductor moves or the magnetic field changes, and the properties of the conductor such as its length and material.

4. What are some practical applications of electromagnetic induction?

Electromagnetic induction has many practical applications, such as in generators and transformers for generating and transmitting electricity, in motors for converting electrical energy into mechanical energy, and in induction cooktops for heating food using a magnetic field.

5. How is electromagnetic induction related to Faraday's law and Lenz's law?

Faraday's law states that the induced electromotive force (EMF) in a closed loop is directly proportional to the rate of change of the magnetic flux through the loop. Lenz's law states that the direction of the induced current in a conductor will be such that it opposes the change that caused it. Both of these laws play a crucial role in understanding and predicting the behavior of electromagnetic induction.

Similar threads

  • Electromagnetism
Replies
16
Views
990
Replies
23
Views
969
Replies
11
Views
2K
Replies
3
Views
942
  • Electromagnetism
Replies
2
Views
1K
  • Electromagnetism
Replies
9
Views
1K
  • Electromagnetism
Replies
1
Views
2K
  • Electromagnetism
3
Replies
74
Views
12K
Replies
13
Views
1K
Replies
11
Views
2K
Back
Top