- #1
michael7777
- 5
- 0
I want to modify a circuit by adding a stronger drive motor.
The circuit is a PCB receiver which is attached to two motors, one which steers a car, one which drives a car.
The previous drive motor needed 2 x 1.5v batteries.
The new drive motor needs a 12V lead acid battery.
This means that 9 more volts will run through the circuit
Here is a block diagram:
Here is the annotated schematic:
I have more information about resistances if there is a need for it.
I am unsure of if the components will still work with such an increase in voltage. So it would be good if someone could advise.
The circuit is a PCB receiver which is attached to two motors, one which steers a car, one which drives a car.
The previous drive motor needed 2 x 1.5v batteries.
The new drive motor needs a 12V lead acid battery.
This means that 9 more volts will run through the circuit
Here is a block diagram:
Here is the annotated schematic:
I have more information about resistances if there is a need for it.
I am unsure of if the components will still work with such an increase in voltage. So it would be good if someone could advise.
Last edited: