Volt-second balance in DC converter coil design?


by hobbs125
Tags: balance, coil, converter, design, voltsecond
hobbs125
hobbs125 is offline
#1
Feb22-13, 05:38 PM
P: 100
Hi everyone,

I working on the design of a small DC converter coil with a step up ratio of about 1:8.
I have been told I need to ensure I maintain a volt-second balance on all windings but I'm not exactly sure what was meant by that.

Do I just need to make sure each winding stays below saturation?

Thanks in advance!
Phys.Org News Partner Engineering news on Phys.org
SensaBubble: It's a bubble, but not as we know it (w/ video)
WSU innovation improves drowsy driver detection
Faster computation of electromagnetic interference on an electronic circuit board

Register to reply

Related Discussions
What is this coil inside this AC to DC power converter? Electrical Engineering 4
DC - DC (boost) Converter Design Electrical Engineering 12
Need help with boost converter design Electrical Engineering 6
how to design a boost converter from 5v to 24v Electrical Engineering 16
design a boost converter Engineering, Comp Sci, & Technology Homework 1