Jan24-14, 07:45 AM
I am writing a paper in development/experimental economics concerning how household bargaining power (i.e. how much say the husband and wife has about how to spend household income) affect how much money is spent on children. I am going to conduct an experiment and is now in the phase of doing some power calculations in order to see how large sample I need. Unfortunately, I am having some problems doing these power calculations. I understand their purpose and everything, but I do not really see how I should use STATA to do the correct calculations.
I am doing a between-subject design with three treatments. In each treatment the money available will be varying. So, I think I need to do power calculations where I compare proportions since I will be comparing the share of money spent on children in each treatment group.
Even though I have three treatments, I will only compare two-and-two treatments. I will compre treatment 1 with treatment 2, treatment 1 with treatment 3 and treatment 2 with treatment 3. So far I have used the following command in STATA:
sampsi 0.1 0.3, power(0.9)
The significance level is then automatically 0.05, and 0.1 and 0.3 is proportions (i.e here the share of money spent on children). Does this make sense??
I have made a table comparing proportions from 0 to 1 (with a 0.1 intervals) and made a table, but I am still not sure whether my method is correct.
|Register to reply|
|How to calculate how big of a sample size is needed for the Central Limit Theorem?||Set Theory, Logic, Probability, Statistics||2|
|Motor size calculations needed||Mechanical Engineering||0|
|Determining sample size needed to test hypothesis||Set Theory, Logic, Probability, Statistics||1|
|Determining sample size needed to test hypothesis||Calculus & Beyond Homework||6|
|sample size needed for power of a study||Set Theory, Logic, Probability, Statistics||5|