|Register to reply||
Volt-second balance in DC converter coil design?
|Share this thread:|
Feb22-13, 05:38 PM
I working on the design of a small DC converter coil with a step up ratio of about 1:8.
I have been told I need to ensure I maintain a volt-second balance on all windings but I'm not exactly sure what was meant by that.
Do I just need to make sure each winding stays below saturation?
Thanks in advance!
|Register to reply|
|What is this coil inside this AC to DC power converter?||Electrical Engineering||4|
|DC - DC (boost) Converter Design||Electrical Engineering||12|
|Need help with boost converter design||Electrical Engineering||6|
|How to design a boost converter from 5v to 24v||Electrical Engineering||16|
|Design a boost converter||Engineering, Comp Sci, & Technology Homework||1|