Register to reply 
Difference power dissipation and actual power dissipation 
Share this thread: 
#1
Jul1913, 05:49 AM

P: 4

Hi,
Is it possible to explain me the difference between "power dissipation" and "actual power dissipation" for a resistor ? I really cant understand the difference... 


#2
Jul1913, 05:59 AM

Mentor
P: 11,815

Do you have some context?
Do you have two different numbers for the same resistor in the same setup? 


#3
Jul1913, 06:05 AM

P: 4

I am reading the standard MILHDBK217F for the reliability of resistors and it talks about "power dissipation" and "actual power dissipation". It just says that "power dissipation" is connected to the power factor and the " Actual Power Dissipation" is connected to the power stress factor but i cant see or immagine any difference between "power dissipation" and "actual power dissipation".



#4
Jul2013, 11:54 PM

PF Gold
P: 1,894

Difference power dissipation and actual power dissipation
mepiace, Welcome to Physics Forums!
I have downloaded MILHDBK217F at http://www.sre.org/pubs/MilHdbk217F.pdf and searched the entire section number nine and cannot find those terms “power dissipation” and “actual power dissipation” anywhere. The only words similar are here: “Section 9.0 The use of the resistor models requires the calculation of the electrical power stress ratio. Stress = operating power/rated power, or per Section 9.16 for variable resistors. ...The rated power for the stress ratio is equal to the full nominal rated power of the resistor.” Will you please post the link or the exact quotation, in context, to assist members here respond to your question. Thank you. 


#5
Jul2213, 03:49 AM

P: 4

Hi,
I have downloaded the standard MILHDBK217F from a different site http://snebulos.mit.edu/projects/ref...7FNotice2.pdf Into the page 92 is mentioned the "power dissipation" in order to calculate the "power factor'. Into the page 93 is mentioned the 'Actual power dissipation" in order to calculate the "power stress factor". I dont know if there is any difference between "power dissipation" and "actual power dissipation". 


#6
Jul2213, 08:06 AM

Engineering
Sci Advisor
HW Helper
Thanks
P: 7,105

In 93 I think the "actual" is just to make clear the difference between the power dissipation of the component in the circuit, and the nominal power rating of the component  e.g. a "10 watt" resistor that is actually dissipating 5 watts has S = 0.5.
In 92 "power dissipation" presumably means what it says, i.e. the same as "actual power dissipation" in 93. But for a quick conservative estimate, assuming the components have been properly specified, you might use the component power rating in 92 instead. The failure rates for most resistors are likely to be low compared with other components in the system. 


#7
Jul2313, 01:43 AM

P: 4

yes, it makes sense. Thank you very much for your answer!



#8
Jul2613, 03:03 PM

P: 561

OH dear god  please do not try to learn from Mil Specs.... haha  in general the "actual" case tends to be a measured or confirmed value.



Register to reply 
Related Discussions  
In binary can we have a value with deci centi mili or more lower valued prefix?  Computers  14  
Strange question, but is time and actual thing ?  Classical Physics  24  
Show that power supplied = power dissipated  Engineering, Comp Sci, & Technology Homework  19  
What's the actual difference between undefined and indeterminate form ?  Calculus  4  
Difference between Identical , Equal , Equivalent  Calculus & Beyond Homework  9 