Register to reply

Handling surface mounts

by haxor489
Tags: handling, mounts, surface
Share this thread:
haxor489
#1
Apr8-13, 02:04 PM
P: 25
I have a GPS module whose footprint was placed on my main PCB by accident and need to find a work around. The EMI from the traces and MCU near the footprint for the module make it less than ideal for the specific requirements of the GPS modules embedded antenna. I've never dealt with surface mounts but is there any way to solder connectors of some sort onto the main PCB so that the module can be mounted on a separate board and connected with extensions wires. I'm completely new to the terminology and my options in this situation, I'd like to avoid having to redraw and reorder the main PCB. If any one could point me in the right direction I'd really appreciate it.
Phys.Org News Partner Engineering news on Phys.org
DIY glove-based tutor indicates muscle-memory potential
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment
jim hardy
#2
Apr8-13, 02:18 PM
Sci Advisor
PF Gold
jim hardy's Avatar
P: 3,684
small quantity ?

try a search on terms pcb surfboard

http://boardworxsystem.com/

http://capitaladvanced.com/6000ser.htm
haxor489
#3
Apr8-13, 03:16 PM
P: 25
Yes just one. Also do you know if there is such a thing as a 2mm pitch female to 2.5mm pitch male converter ?

Disregard this question I've found adapters. Thank you


Register to reply

Related Discussions
Handling a Fraction General Math 2
Anti- Vibration Mounts Mechanical Engineering 1
Anybody know anything about parallelogram mounts Astronomy & Astrophysics 6
Question about handling General Engineering 1
NAN handling in C Computing & Technology 5