Register to reply 
[Hanging/Sliding Chain Problem] Confusion in Normal Force 
Share this thread: 
#1
May813, 05:38 AM

P: 5

This is a very basic problem which you all must have seen somewhere. But recently an itching doubt has come up to me regarding this problem.
Problem: A chain lies on a table with some part of it hanging over the edge. Now if the coefficient of friction is μ, then find out the maximum part of the chain that can hang without sliding. The Usual Solution See the solution to the problem here: http://cnx.org/content/m14806/latest/ Confusion Now, in solving the problem, they considered the part of the chain on the table as "m1" and the hanging part as "m2". Then, they say that: μ*NormalForce = m2*g [itex]\Rightarrow[/itex] μ*m1*g = m2*gNow, my confusion is that why did they take normal force to be = m1*g?? Consider an FBD of the whole chain. Now the only force in the vertically above direction is the normal force. And it should balance all of the weight i.e. (m1+m2)*g. So according to me, normal force = (m1+m2)*g. However, all the solutions that I've seen take normal force = m1*g. But I just don't get it. Thanks in advance. 


#2
May813, 06:49 AM

Sci Advisor
HW Helper
Thanks
P: 26,148

hi champu123!
the usual question has zero friction, and asks you for the acceleration of the chain, and even with no friction, that's less than g because of the increased normal force 


#3
May813, 09:51 AM

Sci Advisor
HW Helper
PF Gold
P: 2,010

What you say seems reasonable, but the result mu=m2/(m1+m2) is not reasonable.
That would say that as m1> 0, the string would still remain at rest if mu were equal to at least 1. Look at a free body diagram of the horizontal part of the string up to just short of the edge The normal force on it is indeed m1g, since the only other vertical force is m1g down. The answer is that there is a vertical upward force m2g on the hanging part of the string by the edge of the table. This is more clearly seen if you consider a pulley at the end of the table. Then the upward force by the pulley is seen from a FBD of the pulley. 


#4
May813, 10:44 AM

Sci Advisor
HW Helper
Thanks
P: 26,148

[Hanging/Sliding Chain Problem] Confusion in Normal Force
Hi Meir!
it depends on the structure of the chain where it is … but unless the edge of the table is smooth, doesn't that still give the same maximum friction of µ(m_{1} + m_{2})g ? 


#5
May813, 09:35 PM

P: 5

Further,
Correct me if I am wrong. But I think this is a huge blunder all the textbooks have been making. In a real case, the answer should be somewhere between the two extremes. It will be a complex encounter of the structure of chain/edge and the forces acting. And only one thing can clear it for once and for all: Experiment. If someone could perform some experiment using a simple chain and see how far it can hang without falling. The value of "μ" could be obtained from a different experiment. And then see what the results match with. This should be fairly easy to perform in a school physics lab (I'm not in my school right now, vacations!!). 


Register to reply 
Related Discussions  
Normal Force on Sliding Ladder  Introductory Physics Homework  5  
Mass Hanging in Center of Chain Problem  Introductory Physics Homework  9  
The Hanging Chain Problem  Introductory Physics Homework  1  
Normal force  object sliding with velocity  Introductory Physics Homework  9  
Force and Motion Sliding/Hanging Blocks  Introductory Physics Homework  3 