Register to reply

Inverter propagation delay using the RC delay model

by Toyona10
Tags: cmos, delay, inverter, model, propagation, rc model
Share this thread:
Feb21-14, 10:45 PM
P: 31

Actually Im fine with calculating the delay but I havent got the concept clearly enough. Both nmos and pmos have their equivalent RC models. I understand how the RC model of nmos works when its on or off but I dont get how the pmos turns out this way. When its off, the upper part wont work because its open circuit but when its on, isnt the resistor supposed to be included? Why isnt it there in the inverter's equivalent RC model when the pmos is on?
Attached Thumbnails
Phys.Org News Partner Engineering news on
Philips introduces BlueTouch, PulseRelief control for pain relief
3-D printing leads to another advance in make-it-yourself lab equipment
Nanoscience makes your wine better
Feb22-14, 11:41 AM
P: 535
The resistor in the RC delay model is either the PMOS or the NMOS. They are both connected to "ground" because in either case the output is connected to a small signal ground (VDD in the PMOS case or VSS in the NMOS case) so as far as the delay model is concerned they are equivalent.

So to answer your question, yes the delay model does include the on-resistance of the PMOS when it is on.

Register to reply

Related Discussions
Delay through CMOS Inverter. General Engineering 1
Calculate Delay of inverter in LTspice Engineering, Comp Sci, & Technology Homework 0
How to measure voltage rise delay and fall delay? Engineering, Comp Sci, & Technology Homework 2
Propagation Delay of Traces on PCBs Electrical Engineering 13
Propagation delay for carry lookahead adder Engineering, Comp Sci, & Technology Homework 0