|Share this thread:|
May1-14, 07:21 AM
im designing a pneumatic filling machine with four filling heads. in all 7 cylinders are working simultaneously through p l c. the filling volume will be 100 ml/bottle within 6 seconds. what should be the working pressure of air so that i can decide the capacity of compressor.
the bore size of the cylinders are mentioned below.
dia 2 inches -- 4 cylinders
dia 3.5 inches -- 1 cylider
dia 0.75 inches -- 2 cylinder
|Register to reply|
|Design of a machine/ machine component||Mechanical Engineering||3|
|Machine A and machine B are performing the same task||Engineering, Comp Sci, & Technology Homework||5|
|Pneumatic circuit.||General Engineering||0|
|Material in machine tool body (milling machine)||Materials & Chemical Engineering||0|
|Transporting machine(actually cloning machine)||General Discussion||15|