Troubleshooting Hot Water Issues in Multi-Story Homes

  • Thread starter danielhudson
  • Start date
  • Tags
    Hot Water
In summary, there is a problem with the hot water not coming out of the bathroom sink tap in a three-story, old home (built in 1902) with a ground floor tenant. The kitchen sink tap and third floor bathroom sink tap work fine, but the second floor bathroom sink tap has never gotten hot unless someone takes a shower beforehand. The house has a tank water heater and the closest bathroom to it is the one on the ground floor. The conversation suggests that there may be a problem with the hot water pipes being connected or plugged up, and that installing point-of-use hot water heaters may be a solution. It is also mentioned that there could be a tempering valve issue or a stuck plunger in the mixing valve.
  • #1
danielhudson
Hey there.
So we have an old home (1902) that is 3 stories.
We currently have a tenant in our ground floor apartment. She just informed me that she is unable to get the hot water to come out of the bathroom sink tap.
She could let it run and run and it will not get hot at the sink tap.
Her kitchen sink tap works fine.
Our kitchen sink tap works fine.
Our 3rd floor bathroom sink gets hot pretty quickly but
our 2nd floor bathroom sink tap has the same problem that out tenant does...
Our 2nd floor bathroom sink hot water has NEVER gotten hot (unless I take a shower in there beforehand) and we've just learned to live with it, since our primary bathroom is on the 3rd floor...
Anyway, this is a new problem ( we think) for our ground floor bathroom sink as our previous two tenants never mentioned it.

We have a tank (blech) water heater 80 gal on the ground level of the house, so her bathroom is actually the closest to the source of hot water.

We can't figure this out.

Any ideas oh plumbing gifted folks out there? Thanks!
 
Physics news on Phys.org
  • #2
The hot water pipes probably aren't all connected up (that's probably 100+ years of people doing renovations / fixits), or have been plugged up. How good's the electrical? If it's decent, you can put in some Point-of-Use hot water heaters (don't go for the ones with tanks--they require between 20 and 50 A of current to give you that instant hot water!) Something like this, perhaps (we use the GL4 to give us enough hot water to fill up a sink and wash our labware for the day):
http://www.boschhotwater.com/BoschHotWatercomHome/PointofUseProducts/tabid/405/Default.aspx
 
Last edited by a moderator:
  • #3
If the water actually runs out of the faucet when only the hot tap is open,
and
if there is never any hot water coming out of that faucet, while hot water does come out of a different faucet at the same time,
then
that hot water line is connected in some way to the cold water source (main).

Another way to check if this is true: at the water heater, there should be a main hot water shutoff valve (on the pipe leaving the "hot" outlet of the heater). Turn this valve off. Check the sink in question. If things were connected correctly, the cold tap should flow, and the hot tap should not do anything. If water flows when the hot is open, then that line is connected to the cold source.

If so, there are two possible scenarios I can think of: some idiot screwed up, and your previous tenants never mentioned it; or
there is a tempering valve (thermostatic mixing valve) that needs to be adjusted or replaced. This mixing valve is used whenever water temperatures are regularly set above 150˚ F. If this valve is stuck open, then cold water will come out of the hot.

You can check if this is the case: with the main hot shutoff valve still off, check the hot tap of a sink that has been working correctly. If water comes out, then cold water is crossing through the mixing valve and backing through the hot line back up to the other sinks.
 
Last edited:
  • #4
I had the same problem with one of mine. The problem was a stuck plunger in the mixing valve. Took it apart and cleaned it - problem solved. Note that manual ones at the faucet are much more common than automatic ones at the system though not mutually exclusive.
 
Last edited:

1. What causes hot water plumbing problems?

There are a few common causes of hot water plumbing problems, such as sediment buildup in the water heater, a malfunctioning thermostat, or a faulty heating element. Other factors, like old or corroded pipes, can also contribute to issues with hot water flow and temperature.

2. How can I prevent hot water plumbing problems?

To prevent hot water plumbing problems, it is important to regularly maintain your water heater by flushing it out to remove sediment buildup. It is also a good idea to have a professional inspect your water heater and pipes periodically to check for any potential issues. Additionally, being mindful of the age of your water heater and replacing it before it becomes too old can help prevent future problems.

3. What are the signs of a hot water plumbing problem?

Some common signs of a hot water plumbing problem include low water pressure, inconsistent or no hot water, strange noises coming from the water heater, and leaks. If you notice any of these signs, it is important to address the issue promptly to avoid further damage.

4. Can I fix hot water plumbing problems myself?

In some cases, you may be able to fix hot water plumbing problems yourself, such as adjusting the thermostat or flushing out sediment from the water heater. However, it is always best to consult a professional plumber for more complex issues. Attempting to fix a plumbing problem without the proper knowledge and experience can result in further damage and potentially costly repairs.

5. How much do hot water plumbing problems typically cost to repair?

The cost of repairing hot water plumbing problems can vary greatly depending on the specific issue and the extent of the damage. Minor issues like replacing a heating element or fixing a leak can cost a few hundred dollars, while more extensive repairs such as replacing a water heater can cost upwards of a thousand dollars. It is best to consult a professional plumber for an accurate estimate of the cost for your specific issue.

Similar threads

  • Other Physics Topics
Replies
11
Views
401
Replies
9
Views
1K
Replies
12
Views
3K
Replies
3
Views
971
Replies
2
Views
1K
  • General Discussion
Replies
6
Views
1K
Replies
13
Views
31K
  • General Discussion
Replies
30
Views
4K
  • General Discussion
2
Replies
41
Views
7K
Back
Top