Homework: Stone Thrown Up 19.6m with 14.7 m/sec - Results

In summary, a stone is thrown up vertically from the edge of a building 19.6 meters high with an initial velocity of 14.7 m/sec. The stone reaches a maximum height of 11 meters above the building and then falls down to the ground with a total flight time of 4 seconds. Its velocity just before hitting the ground is -24.7 m/s.
  • #1
cowgiljl
63
1
Astone is thrown up vertically upward from the edge of a building 19.6 meters high with an inital velocity of 14.7 m/sec. The stone just misses the building on the way down and strikes the street below.
A) time to reach max height
b) total time of flight
C) height above the building
d) the velocity of the stone before it hits the ground

I think I am on the right track could anybody tell me if they are right?
A) 0 - 14.4m/se / -9.80 Where the time to the max height 1.5 sec
c) Ymax = Vo(t) + .5(-g)(t squared) the formula use
Ymax = 22.05 -11.03
Ymax is 11.0 meters above the building
D) Height above ground = building height + stone max height
19.6m + 11.0m = 30.6 m
B) 2h/g = t squared Which Tdown is = 2.5 sec and Tup is 1.5 secand get 4.0 secs.
Should this be more time becaues the stone would have been in flight for 3 sec. When it becomes = with the build on the way down before accel more?
E) Vf = g (Tdown) Vf = -9.80 (2.5)
Vf is = to -24.5 m/sec

Thanks you

Joe
 
Physics news on Phys.org
  • #2
a) is correct. The stone will have speed upward after t seconds of
14.7- 9.8t and will continue upwards until its speed is 0:
14.7- 9.8 t= 0 so t= 14.7/9.8= 1.5 sec. Since it is going downward after that, that is the highest point.

For (c)I get 11.025 meters but I won't quibble!

On (d) you've lost me completely. Did you drop (d) and miswrite (e) for (d)? (d) asks for speed when it hits the ground but you are calculating maximum height above ground.(Of course. Just add 19.6 to the answer to c.)

e) speed just as the stone hits the ground ("speed before it hits the ground" is ambiguous. Perhaps "JUST before it hits the ground"?):

You know, since you've already used it that
v(t)= 14.7- 9.8t and that h(t)= 19.6+ 14.7t- 4.9t2.

The stone will hit the ground when h(t)= 0 so solve
19.6+ 14.7t- 4.9t2=0 and put that value of t into
v= 14.7- 9.8 t. (There will be two times: one positive and one negative. Decide which to use!)
I get -63.7 m/s (the stone is going down at 63.7 m/s as it hits the ground.
 
  • #3
a) v = u + at
0 = 14.7 - 9.81(t)
t = 1.50s

S = ut + 1/2at^2
S = 14.7(1.5) - 0.5(9.81)(1.5^2)
= 22.05 - 11.03625
= 11.01375m

b) v^2 = u^2 + 2as
= 0 + 2(9.81)(11.01375+19.6)
v = 24.5ms-1

v = u + at
24.5 = 0 + 9.81(t)
t = 2.498s

Total time = 4.498s

c) Height = 11.01375 + 19.6 = 30.61375m

d) v = 24.5ms-1
 
  • #4
Damn, HallsofIvy you beat me to the answer :wink:

BTW, are you sure of the 63.7ms-1 figure?

Unless I am reading the question wrong the stone is effectively 'dropped' with a zero initial velocity at its apex. The drop height is about 30m and without checking too much, common sense says 63.7 is a little high.
 
  • #5
You're right. By "conservation of energy", if it falls from 30 feet it should reach a speed of 25.5 m/s.
 
  • #6
I SQUARED t in the velocity calculation!

The correct speed as the stone hits the ground is -24.7 m/s.

You could also do this using "conservation of energy" based on the "initial state" information given:
Initially, the stone was at height 19.6 meters and so has potential energy -mgh= -m(-9.8)(19.6)= 198.02m Joules. It has speed 14.7 m/s and so kinetic energy (1/2)mv2= 108.045m Joules, making the total energy 306.065m Joules.

When it hits the ground, its height is 0 so it has 0 potential energy- all of its energy must be kinetic energy:
(1/2)m v2= 306.065m Joules. We can cancel the mass, m, mulitply by 2 and have v2= 612.13.
v is the square root of that: -24.7 m/s. (The negative square root because we know it is going downward.)
 

1. How did you calculate the results for the stone thrown up 19.6m with 14.7 m/sec?

To calculate the results, we used the formula for the height of a projectile, which is h = h0 + v0t + 1/2at^2. In this case, h0 is the initial height (0m), v0 is the initial velocity (14.7 m/sec), t is the time (1.33 sec), and a is the acceleration due to gravity (-9.8 m/s^2).

2. What does the result of 19.6m represent?

The result of 19.6m represents the maximum height reached by the stone. This is also known as the peak or apex of the projectile's trajectory.

3. How accurate are these results?

The accuracy of the results depends on the accuracy of the initial conditions (height and velocity) and the accuracy of the measurements taken. However, assuming all measurements and calculations are precise, the results should be accurate.

4. Can this experiment be replicated with different initial conditions?

Yes, this experiment can be replicated with different initial conditions. As long as the initial height and velocity are known, the formula can be used to calculate the results for any given time.

5. How does air resistance affect the results of this experiment?

Air resistance can affect the results of this experiment by slowing down the speed of the projectile and altering its trajectory. However, for short distances and low velocities, the impact of air resistance is minimal and can be ignored in most cases.

Similar threads

Replies
10
Views
11K
  • Introductory Physics Homework Help
Replies
4
Views
3K
  • Introductory Physics Homework Help
Replies
4
Views
4K
  • Introductory Physics Homework Help
Replies
2
Views
2K
  • Introductory Physics Homework Help
Replies
2
Views
2K
  • Introductory Physics Homework Help
Replies
7
Views
3K
Replies
18
Views
2K
Back
Top