Register to reply

Gear reduction

by cbp5029
Tags: gear, reduction
Share this thread:
cbp5029
#1
Jun12-14, 10:03 AM
P: 1
I have a 3hp motor, with a torque of 110.85 lb*in. a gear box with a max torque of 6286 lb*in.

gear box ratio is 57.64:1

I have gears attached to the gearbox shaft with a gear reduction of 3.375:1.

My new gear ratio should be 194.53:1 right?....

which would make my output torque approx. 21,500 lb*in...?

just checking
Phys.Org News Partner Engineering news on Phys.org
Tiny UAVs and hummingbirds are put to test
Britain to trial driverless cars from 2015
NIST corrosion lab tests suggest need for underground gas tank retrofits
Travis_King
#2
Jun12-14, 10:57 AM
P: 827
Are you sure about your motor's torque? I ask because you list the gearbox's max torque (is that it's rated torque) at a value that is lower than the motor torque*reduction.

Also, understand that AC motors (if that's what you are using) are not constant torque machines. They have torque curves, and starting/peak torque can be upwards of 200% (in some cases much higher) of rated torque.

I'd verify you've got the right parts for the application.

As per your question, yes, if you have a gearbox with a 57.64:1 ratio and the output of that is subjected to another 3.375:1 reduction, you will have a 194.53:1 reduction and theoretical torque of 21,500 in*lb (depending on efficiency of the powertrain).


Register to reply

Related Discussions
A mechanics problem involving a large gear and a small gear Engineering, Comp Sci, & Technology Homework 1
Gear reduction question Mechanical Engineering 6
Gear mechanism and wheel arrangement for reduction of fuel consumption Mechanical Engineering 1
Double Reduction Gear Mechanical Engineering 7
Number of gear teeth in two-stage reduction gears Mechanical Engineering 11