- #1
unknown_2
- 29
- 0
hey, I've been looking at ways to create a LED chaser using a 555 timer chip and 2 x 4017 decade counter chips(more than 10 LEDs). mind you I've only been working with these chips for an hour. so here's the dilemma, I'm not quite sure if I'm right on connecting the 2 chips. what i did was connect the carry output pin of the first chip to the clock pin of the second chip. then i connected one of the last output pins of the second chip to both reset pins of the decade counters. i have provided a schematic below. is this correct or am i missing something?
Schematic: http://i20.photobucket.com/albums/b219/twiztedazn/SCHEMATIC1_PAGE1.jpg"
thanks,
Schematic: http://i20.photobucket.com/albums/b219/twiztedazn/SCHEMATIC1_PAGE1.jpg"
thanks,
Last edited by a moderator: