
#1
Nov2713, 05:49 AM

P: 4

Hey,
Once again, I got a question about quaternions. Say I have an initial rotation Q1. I now want to rotate Q1 on the X and then on the Y axis. BUT: The Y rotation should apply to the local Y axis which was given in Q1. The problem is: If i rotate Q1 by the Xrotation Q2, then the Y axis changes for Q1*Q2. So, since quaternion multiplication is noncommutativ, if I then apply the Yrotation Q3, I don't rotate about the original Y axis of Q1. How can I rotate quaternions this way? Greetings! 



#2
Dec113, 01:54 PM

P: 13

I assume that the rotations around X and Y will be achieved by applying by two separate quaternion increments, call them QX and QY. Assuming this is the case I think you need to proceed as follows;
1. apply the QX rotation to Q1, call the result R1. 2. apply the QX rotation to the QY rotation increment  this transforms the Y axis rotation from the original frame of reference to the frame that exists after you've done the X rotation. Call the modified QY increment QY' 3. apply QY' to R1 


Register to reply 
Related Discussions  
P(x) has two local maxima and one local minimum. Answer the following  Calculus & Beyond Homework  2  
Global rotation to local?  General Physics  1  
Problem with quaternion rotation maths  Differential Geometry  5  
Coordinate System Rotation Matrix (global to local)  Calculus & Beyond Homework  3  
A proof that all signal local theories have local interpretations.  Quantum Physics  3 