
#1
Dec1013, 10:58 AM

P: 2

Building a large sign. I've attached a drawing of what I'm doing. I need to make sure that 85/8 pipe is sufficient for sign. I live in Oklahoma and we get some nasty winds as well. Please help. Any suggestions greatly appreciated.




#2
Dec1013, 11:09 AM

P: 2,491

Your best bet is to look around your neighborhood for a sign with similar area and construction and see what piping support they use.
You could also pitch your sign project to some local sign company for an estimate and they may show you the piping they will use. 



#3
Dec1013, 11:11 AM

P: 2

I am the sign co. This is much bigger than I typically do.




#4
Dec1013, 11:12 AM

P: 2,491

Large Sign. Need help calculating pipe size.Have you seen any traffic signs of a similar size? I'm thinking that you may need two columns instead of one for stability. 



#5
Dec1013, 11:28 AM

P: 2,491

I found a reference to a sign company that has signs with similar sizes:
http://www.wholesalesignsuperstore.c...utional_signs/ You might be able to get a quote from them and ask about the weight of th sign and the piping needed to properly display it. 


Register to reply 
Related Discussions  
large pictures, A0 size  General Discussion  13  
Design Large Sign for Wind Loads  Mechanical Engineering  12  
Help with determining appropriate pipe size  General Engineering  1  
FFT with very large sample size  Calculus  0  
Calculating pipe size for closed loop watering system  Introductory Physics Homework  2 