Register to reply

Passive/Active Frequency Response

by angelspikes
Tags: frequency, passive or active
Share this thread:
angelspikes
#1
May16-14, 06:54 PM
P: 11
I'm evaluating the Frequency Response and subsequently Step Response of a bandpass filter.
Is the frequency response going to be different for an active bandpass filter from a passive bandpass filter?

I've plotted the frequency response using LTspice with the following setup:

Small signal AC analysis:
AC amplitude: 15 V

Simulation Command:
Type of sweep: Octave
Number of points per octave: 30
Start frequency: 1
Stop frequency: 300

My hand calculations suggest the max frequency should be about 40 kHz.
However, using the -3dB rule, the max frequency ends up on 100 kHz.

Any suggestions?
Phys.Org News Partner Engineering news on Phys.org
Researchers use 3D printers to create custom medical implants
For secure software: X-rays instead of passport control
Razor-sharp TV pictures

Register to reply

Related Discussions
Is the sun a passive or active blackbody? General Physics 2
EP and active/passive mass Special & General Relativity 0
Active and passive drag General Physics 1
Morality of passive/active General Discussion 52
Passive or Active Components Electrical Engineering 4