Register to reply

Temperature of dilution

by sout528
Tags: dilution, temperature
Share this thread:
sout528
#1
Feb11-14, 06:49 PM
P: 2
Hi there

If I have 2.5% H3PO4 at 353 degrees C and I need to bring the solution down to 100 degrees C only by adding any amount water, how do I go about the thermo calculation? I need final temperature and amount of water (thus final concentration... likely <0.1 M? ) Heat capacity approaches 1 as concentration approaches 0, and the heat of dilution approaches 0 in the same way. Thanks for any advice.
Phys.Org News Partner Science news on Phys.org
New type of solar concentrator desn't block the view
Researchers demonstrate ultra low-field nuclear magnetic resonance using Earth's magnetic field
Asian inventions dominate energy storage systems
Borek
#2
Feb12-14, 02:14 AM
Admin
Borek's Avatar
P: 23,528
That's just a heat balance, but as you start close to critical point the main problem is that the heat capacity changes. Instead of using q=mcΔT you need to use

[tex]q = m\int c dT[/tex]

and integrate from Tstart to Tfinal.


Register to reply

Related Discussions
Dilution Question Chemistry 1
Acid dilution Biology, Chemistry & Other Homework 3
2 fold dilution Introductory Physics Homework 0
Dilution and moles Biology, Chemistry & Other Homework 3
Dilution Question Biology, Chemistry & Other Homework 4