Register to reply

Integrating op amp question

by Cantstandit
Tags: integrating
Share this thread:
Mar5-13, 03:18 PM
P: 30
I'm having problem understanding the output of the integrating op amp.
(hope you can see that, I can't see it on my preview)

The blue line is input, orange is output. So if it's supposed to integrate, surely output signal has a wrong sign, doesn't it? If the integral is the area under the square signal, there should be linear increase when the signal is positive and linear decrease when it's negative, yet it's the other way around, why? I'd thought it was because my voltage had been applied to the inverting input of the op-amp, but even when I flipped it, it stays the same...
Phys.Org News Partner Engineering news on
DIY glove-based tutor indicates muscle-memory potential
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment
jim hardy
Mar5-13, 07:03 PM
Sci Advisor
PF Gold
jim hardy's Avatar
P: 3,679
Remember you have an inverting amplifier there.
The opamp will hold its inputs equal, and +input is at zero.
Therefore whatever current is pushed into summing junction through R1 must get pulled back out through C1&R2,,,,
,,,so an input to output reversal of polarity is nessary.

After the initial transient (power up i presume?) , output looks like it moves in right direction.

Register to reply

Related Discussions
Integrating factor question Calculus & Beyond Homework 0
ODE question - Integrating factor Calculus & Beyond Homework 2
Question regarding integrating (int(1/u)) Calculus & Beyond Homework 1
Question integrating |f(z)||dz| over a contour C Calculus & Beyond Homework 4
Quick integrating question...(part of a series question) Calculus & Beyond Homework 3