Register to reply

How do stiffener beads work?

by leomclaughlin
Tags: beads, stiffener, work
Share this thread:
Jul11-14, 08:07 AM
P: 8
Attached is a picture of a stiffener bead on a metal link, my question is how does this shape help stiffen the part? Why is this superior to simply having a flat metal link?
Attached Thumbnails
Phys.Org News Partner Engineering news on
DIY glove-based tutor indicates muscle-memory potential
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment
Jul11-14, 08:27 AM
P: 788
Imagine the difference between a flat piece of cardboard and the same thing bent into a partial tube. (You could try this at home!)
Jul11-14, 08:37 AM
P: 8
well could you be more specific regarding the material shown in the image? Also about which axes does this stiffener bead stiffen/weaken?

Jul11-14, 01:24 PM
P: 7
How do stiffener beads work?

If I recall correctly, the added strength is due to the second moment of area (aka area moment of inertia).

Taking your example, assuming the end with the green dot is fixed and a load is applied to the other end, the dart will improve the link's resistance to deflection into and out of the screen.
Jul12-14, 07:22 AM
P: 157
Commenter jackwhirl is on the right path. And I will also say "if I recall correctly" because I haven't done this in decades. The equation for beam bending uses an area moment term for the cross section of the beam. Apply a ridge or other type of feature to the beam and beam stiffness increases. This is due to the area moment term of the cross section increases.
Jul12-14, 10:14 AM
P: 2,048
Wiki Flexural rigidity.

The term of interst as stated above is I.

The further away from the bending axis the material the more contribution it makes to the stiffness. Material along the axis makes little contribution.

It's important to remember that this bracket will will not be loaded in the intended plane like in a FBD/theory. It will be have to have stiffness in its other degrees of freedom.

So by pressing some material out to the side you are adding torsional stiffness for a tiny loss of bending stiffness.

Edit: this looks suspiciously like a schoolwork type question.

Register to reply

Related Discussions
Ansys WB, getting non-realistic stress conce. (stiffener tip on pipe column face)? General Engineering 5
Two 1.0-g beads are charged ....? Introductory Physics Homework 2
How do ferrite beads work? General Physics 1
Frictionless, rotating circular hoop Introductory Physics Homework 4
A bag contains two red beads and two green beads General Math 3