kingdomof said:If it's volume, check out density after finding the stoichiometric constant for the balance equation and finding the mol of sodium bicarbonate.
Stoichiometry is the calculation of the quantities of reactants and products involved in a chemical reaction. In HCl problems, stoichiometry is used to determine the amount of HCl needed to react with a given amount of a different substance, or the amount of HCl produced from a given amount of reactants.
To balance a chemical equation for an HCl problem, you must ensure that the same number of atoms of each element are present on both sides of the equation. This is done by adjusting the coefficients (numbers in front of the chemical formulas) until the number of atoms for each element is equal on both sides of the equation.
The molarity of HCl is the concentration of a solution, expressed in moles of HCl per liter of solution. It is often used in HCl problems to calculate the amount of HCl needed or produced in a reaction, using the formula M1V1 = M2V2, where M1 and V1 are the initial molarity and volume, and M2 and V2 are the final molarity and volume.
The stoichiometric ratio is the ratio of reactants and products in a chemical reaction, based on the coefficients in the balanced equation. In HCl problems, the stoichiometric ratio is used to determine the amount of HCl needed or produced in a reaction, and can also be used to calculate the amount of other substances involved in the reaction.
Some common sources of error in HCl stoichiometry problems include inaccurate measurements of reactants and products, incomplete reactions, and errors in the balanced equation. It is important to double check all calculations and make sure the equation is properly balanced to minimize these sources of error.